Increase The Performance Of  Your 
Powder Spray System With Our 
New Static-Check STC3

Why do you need one for your coating line?

Electrostatic -
On Electrostatic powder guns the actual high voltage output can differ from the voltage reading that appears on the control unit. Most units have a circuit inside that measures the high voltage. Because of problems with both the cable and/or the gun readings from the circuit can actually be far different from the actual output. For example when your gun becomes coated with even a thin film of powder this can cause the high voltage current to dissipate towards the ground connection.

On electrostatic units the actual gun output is crucial to coating efficiency. Our Static-Check STC3 is a tool that you can immediately use to monitor your actual voltage output and take control of your powder coating operation.

Tribo -
On Airstatic or "Tribo" guns the powder develops an electric charge during its passage through the spray barrel. The Static-Check STC3 measures the actual charge of the powder in uA which allows you to determine if the powder is suitable for "Tribo" charging.

Correct Ground Contact -
The Static-Check STC3 can be used additionally to check the ground resistance of parts before they go into the spray booth. If parts are not grounded correctly the powder will simply not stick to them whether it is sprayed with an ES or a Tribo gun.

Wouldn't you like to have a scientific device that helps you determine exactly why your powder system isn't working properly?

The Static-Check STC3 Will Optimize Your Powder Application System By - 
+ Helping you control how much powder goes on each part;
+ Limiting overspray and wasted powder;
+ Testing to determine whether you have a powder problem    or a gun problem;
+ Analyzing proper grounding for each part being coated